Majlesi, ArsalanShahriar, AdnanNasouri, RezaKhodadadi Koodiani, HamidMontoya, ArturoDu, AoMatamoros, Adolfo2022-11-242022-11-242022-11-14Journal of Marine Science and Engineering 10 (11): 1751 (2022)https://hdl.handle.net/20.500.12588/1416Finite element (FE) models that simulate wave–superstructure interactions with the coupled Eulerian–Lagrangian (CEL) technique provide a viable and economical solution to estimate wave impact forces on bridge superstructures. One of the main drawbacks of CEL FE models is that they produce solutions distorted by numerical artifacts with very high frequencies that make it difficult to quantify the magnitude of hydrodynamic forces on superstructures. This paper investigated digital filter parameters for horizontal forces extracted from CEL FE models. The optimal filter configuration was evaluated by comparing unfiltered and filtered horizontal force signals with experimentally measured values from a reduced-scale superstructure specimen tested at the O.H. Hinsdale Wave Research Laboratory at Oregon State University. It was found that digital filters with cutoff frequencies below the fundamental frequency of the superstructure produced the best results and that optimizing Eulerian–Lagrangian surface interactions significantly improved the quality of the calculated force signals.Attribution 4.0 United Stateshttps://creativecommons.org/licenses/by/4.0/coastal bridgeswave–structure interactioncoupled Eulerian–Lagrangian analysisfinite element modelfilteringArticle2022-11-24